Plaster starting cement-lime mixture — V MP START
Starters
Adhesive mixture for gluing insulation polystyrene foam and mineral wool plates — VT 30
- 25 kg Package weight
- 54 bags/1350 kg Quantity per pallet
Adhesive mixture for gluing insulation polystyrene foam and mineral wool plates — VT 30
Field of application:
For gluing facade polystyrene and mineral wool insulation plates. The mixture is used for all facade insulation systems using the «light wet» method for gluing insulation boards (polystyrene foam and mineral wool).
Features:
- plastic and easy to use;
- long open time;
- high adhesion to the base;
- excellent rheology during application.
Advantages:
5.0....6.0 l.
More about the product
-
Specifications
Storage Cement, mineral fillers, polymer modifiers, reinforcing microfibers
Water consumption per 25 kg (kg) of dry mixture, l (l)
5.0....6.0 Consumption of dry mixture per 1 m² (m2) with a layer thickness of 1 mm (mm)
Approximately 1.6 kg (kg) Consumption of dry mixture per 1 m² (m2)
Approximately 4.5-6.5 kilograms (kg) Expiry date, min (min)
At least 120 Adjustment time, min (min) At least 15 Adhesion strength to the base after
endurance in air-dry conditions, MPa (MPa)
Not less than 0.5 Coarseness of aggregate, mm (mm) Not more than 0.8 Frost resistance, cycles
At least 50 -
Preparation of the base
It is carried out in accordance with DSTU-NB A.3.1-23:2013 and DSTU-NB B.2.6-212:2016. The surface of the base must be dry, strong, even, with low and uniform water absorption. Before applying the dry mixture, the surface is cleaned of dust, oil stains and other substances that reduce adhesion. In winter, there should be no ice or snow on the surface. Surfaces that are weak and highly absorbent should be pre-treated with primers, according to the purpose.
-
Preparation of the solution
Preparation of mortar mixture: pour water into a clean container (water temperature from +15 °C to +25 °C) at the rate of 0.2-0.24 l (l) per 1 kg (kg) of dry mixture (5.0-6 .0 l (l) per 25 kg (kg)), gradually add the dry mixture and mix with a low-speed mixer until a homogeneous mass without lumps is obtained. After 5 minutes mix again.
-
Recommendations
The use of dry mixture is recommended at temperatures from +5 °C to +30 °C and relative air humidity not higher than 65%. The freshly laid mixture must be protected from rapid drying, from rain and direct sunlight. Eyes and skin should be protected during work. If the mixture gets into the eyes, it is necessary to immediately wash them with water and consult a doctor.
-
Execution of works
Add a 25 kg bag of dry mixture gradually to a container with 5-5.5 liters of clean water (water temperature from +15 °C to +20 °C), mix with a construction mixer until a homogeneous mass is formed. Leave for 5 minutes and mix again. Time used up
-
Packaging
Paper bags with an inner polyethylene layer of 25 kg.
-
Storage
The mixture must be stored in the company's airtight packaging in a dry room, on pallets. The shelf life is 12 months from the date of manufacture indicated on the package.
-
Cost
On average, 4-6 kg of glue is used per 1 m2, depending on the thickness of the applied layer and the condition of the surface.
